Conveners
6.9 Research Reactors
- Alexander Tuzov (Joint Stock Company "State Scientific Center - Research Institute of Atomic Reactors")
- Hidemasa Yamano (Japan Atomic Energy Agency)
Dr
Dongjin EUH
(Korea Atomic Energy Research Institute)
29/06/2017, 10:20
Track 6. Test Reactors, Experiments and Modeling and Simulations
ORAL
Korea Atomic Energy Research Institute (KAERI) is currently developing the prototype SFR under the program of mid and long term project of the Korean government. Various experimental programs were selected for the validation of thermal fluidic design of the reactor system and design codes as the results of the PIRT. For a core thermal design, the assessment of the thermal margin is very...
Mr
Alexander Belov
(Nuclear Safety Institute the of Russian Academy of Sciences)
29/06/2017, 10:40
Track 6. Test Reactors, Experiments and Modeling and Simulations
ORAL
The necessity in detailed engineering codes to perform neutron-physical calculations of the core of nuclear facility is caused by the problems arising during fast reactors design and operation. Diffusion program complexes of neutron-physical calculations with different degrees of assembly representation has been developed and used in IBRAE RAN.
The FUBUKI program is intended for...
Mr
Alexey Izhutov
(JSC “SSC RIAR”)
29/06/2017, 11:00
Track 6. Test Reactors, Experiments and Modeling and Simulations
ORAL
The fast research reactor BOR-60 is one of the world’s leading research reactors in large-scale testing of fuel, absorbing and structural materials to design new advanced fast reactors, pressurized water reactors, gas-cooled and fusion reactors, and demonstrate the feasibility of lifetime extension for VVER and BN-type reactors.
BOR-60 was commissioned in December 1969, and by early 2017 it...
Mr
Dmitry Klinov
(JSC “SSC RF-IPPE”, Obninsk)
29/06/2017, 11:20
Track 6. Test Reactors, Experiments and Modeling and Simulations
ORAL
The main task of the measurements at different stages of the reactor start-up (first criticality, first start and further testing of the rated power) is to obtain complete and accurate information on the monitored neutronic parameters of the core. It is essential for subsequent reactor operation and also helps to verify and improve the accuracy of calculating neutronic parameters.
Insertion...
Mr
Andrey Gulevich
(SSC RF-IPPE)
29/06/2017, 11:40
Track 6. Test Reactors, Experiments and Modeling and Simulations
ORAL
Reactor MBIR will start operating in the absence of loop channels, which represent technologically complex equipment. At the initial stage of operation this will make it possible, on the one hand, to develop technological modes of reactor facility operation with small amount of experimental devices, and on the other hand, with this development, to gradually fill the cells intended for the loop...