Since 18 of December 2019 conferences.iaea.org uses Nucleus credentials. Visit our help pages for information on how to Register and Sign-in using Nucleus.

17–22 Oct 2016
Kyoto International Conference Center
Japan timezone

Effects of ECH and RMP on Argon Impurity Transport in KSTAR Plasmas

19 Oct 2016, 14:00
4h 45m
Kyoto International Conference Center

Kyoto International Conference Center

Takaragaike, Sakyo-ku, Kyoto 606-0001 Japan
Poster EXW - Magnetic Confinement Experiments: Wave–plasma interactions; current drive; heating; energetic particles Poster 4

Speaker

Mr Joohwan Hong (Korea Advanced Institute of Science and Technology)

Description

Experiments were conducted in KSTAR plasmas by injecting a trace amount of Ar gas as a test particle while applying two different actuators: electron cyclotron resonance heating (ECH) and resonant magnetic perturbation (RMP). Effects of ECH was investigated in KSTAR L- and H-mode discharges. For L-mode discharges (I_p = 400 kA, B_t = 2 T), 110 GHz ECH of 350 kW was applied to heating positions varied in the vertical direction. The Ar radiation, measured by soft X-ray (SXR) array diagnostics showed significant reduction in the core impurity emissivity with the ECH. The reduction was the largest by on-axis ECH heating and became smaller as the heating was delivered at outer locations. For H-mode plasmas (I_p = 600 kA, B_t = 2.8 T, P_NBI ~ 4.0 MW), 170 GHz ECH of 800 and 600 kW was applied to the positions of Z = 0 at fixed R = 1.66 m. Emissivity measurements of 3.4 nm (Ar^16+) by X-ray (XICS) and 35.4 nm (Ar^15+) by VUV spectrometers indicate that the ECH reduced the peak emissivity of the Ar^15+; however, the ECH increased the emissivity of the Ar^16+. It was observed that the ECH effects for reducing (Ar^15+) and increasing (Ar^16+) emissivity were stronger with higher heating power. Ar impurity transport experiments using +90 phasing of n = 1 RMP was also studied in the H-mode plasma (I_p = 0.5 MA, B_t = 2.15 T, P_NBI ~ 3.0 MW). The RMP coil current (I_RMP) was scanned from 0 to 2.5 kA and the trace Ar gas was puffed under the RMP. It was observed that the increase of I_RMP reduced line-averaged electron density by up to 15% and increased the ELM frequency from 52 Hz to 67 Hz. The peak divertor heat flux and stored energy loss during a single ELM burst were also decreased by the increase of I_RMP, along with mitigation of ELM by the RMP. The SXR radiation at the plasma core was decreased with the increase of I_RMP. These observations imply that the impurity accumulation can be controlled by the RMP application. A detailed discussion on the Ar transport coefficients, i.e. diffusion and convection coefficients, obtained by the ADAS-SANCO impurity transport code analysis will be presented. In addition, the analysis results from neoclassical and gyrokinetic simulation will also be discussed to provide theoretical understanding of the role of ECH and RMP on Ar transport in the KSTAR plasma.
Country or International Organization Republic of Korea
Paper Number EX/P4-18

Primary author

Mr Joohwan Hong (Korea Advanced Institute of Science and Technology)

Co-authors

Dr C. R. Seon (National Fusion Research Institute) Dr H. S. Kim (National Fusion Research Institute) Dr Hyunyong Lee (Korea Advanced Institute of Science and Technology) Mr Inwoo Song (Korea Advanced Institute of Science and Technology) Mrs J. W. Yoo (National Fusion Research Institute) Mr Jae Sun Park (Korea Advanced Institute of Science and Technology) Dr Jeong JINHYUN (NFRI) Dr Jongha Lee (National Fusion Research Institude) Mr Juhyeok Jang (Korea Advanced Institute of Science and Technology) Dr Juhyung Kim (National Fusion Research Institute) Dr Jun Gyo Bak (National Fusion Research Institute) Dr Kimin Kim (Korea Advanced Institute of Science and Technology) Dr Sang Gon Lee (National Fusion Research Institute) Dr Seung Hun Lee (National Fusion Research Institute) Dr Stuart Henderson (University of Strathclyde) Dr Won Ha Ko (National Fusion Research Institute) Prof. Wonho Choe (Korea Advanced Institute of Science and Technology)

Presentation materials