Since 18 of December 2019 conferences.iaea.org uses Nucleus credentials. Visit our help pages for information on how to Register and Sign-in using Nucleus.

22–27 Oct 2018
Mahatma Mandir Conference Centre
Asia/Kolkata timezone
CONFERENCE MATERIAL NOW AVAILABLE!

Pump Characterization of 80 K Liquid Nitrogen Booster System for SST-1

26 Oct 2018, 08:30
4h
Mahatma Mandir Conference Centre

Mahatma Mandir Conference Centre

Gandhinagar (nearest Airport: Ahmedabad), India
Poster FIP - Fusion Engineering, Integration and Power Plant Design P7 Posters

Speaker

Mr Gaurang Mahesuria (Ipr)

Description

The Steady state superconducting Tokamak (SST-1) is medium size tokamak, which requires liquid nitrogen (LN2) cooled 80 K bubble shields for reducing direct static heat load from room temperature to superconducting magnets system (SCMS). Dedicated liquid nitrogen booster system has been installed and commissioned to cater 0.7 MPa / 80 K single phase flow for uniform temperature distribution among all the 80 K shields of the SST-1 machine. The boosting system has been driven by three centrifugal cold pumps at liquid nitrogen services. These pumps have been tested at steady state mode around 0.5 MPa / 80 K at the suction and 0.7 MPa / 80 K at discharge. This Pumps can handle the pressure head in the range of 1.3 - 3.5 bar (a) at the rated speed of 5500-7000 rpm respectively, over cryogenic stability. Each of three pumps was characterized at their rated speed by evaluating various differential pressure and mass flow rate. The active current, apparent current and the actual voltages have been measured onset from the frequency controller. Based on these measurements, the efficiency of each pump have been deduced using the rated parameters and the efficiencies were obtained to be in the range of 32 - 45%, which is found to be at satisfactory level as guaranteed.
Country or International Organization India
Paper Number FIP/P7-10

Primary author

Co-authors

Mr Ketan Patel (IPR) Mr L N Srikanth G (IPR) Mr Pankil Shah (IPR) Mr Rakeshkumar Patel (Institute For Plasma Research) Dr Vipulkumar Tanna (Institute for Plasma Research)

Presentation materials