Since 18 of December 2019 conferences.iaea.org uses Nucleus credentials. Visit our help pages for information on how to Register and Sign-in using Nucleus.

# 28th IAEA Fusion Energy Conference (FEC 2020)

May 10 – 15, 2021
Virtual Event
Europe/Vienna timezone
The Conference will be held virtually from 10-15 May 2021

## Role of the separatrix density in the pedestal performance in JET-ILW and JET-C

May 12, 2021, 4:44 PM
17m
Virtual Event

#### Virtual Event

Regular Oral Magnetic Fusion Experiments

### Speaker

Lorenzo Frassinetti (KTH, Royal Institute of Technology)

### Description

Since the initial JET operations with the metal wall (JET-ILW), the experimental results have shown a pedestal pressure in baseline plasmas that tends to be 10-20% lower than in the corresponding earlier carbon wall operations (JET-C) [1]. While this degradation seems mainly correlated with the high fueling rates typical of JET-ILW [2,3] and/or the lack of carbon impurity [4,5], an exhaustive and comprehensive explanation for the lower pedestal performance has not been achieved yet. This work will address the role of fueling and its goals are:

• to prove that the lower pedestal performance in D fuelled JET-ILW plasmas are due to the higher separatrix density ($n_e^{sep}$) produced by the higher neutral pressure,
• to describe the corresponding physics mechanisms that lead to the pedestal degradation.

In the baseline scenario of JET-ILW, operations with no gas-fueling rate have been extremely challenging due to the problems related to tungsten influx and divertor heat loads. Since most of the JET-C plasmas have no gas fueling, a direct comparison of JET-ILW and JET-C pedestals obtained with identical engineering parameters is not possible. A further complication is related to the fact that the peeling-ballooning (PB) stability model (implemented with ideal MHD equations) does not describes correctly the experimental JET-ILW results (the experimental pedestal with high fueling rates does not seem to reach the stability boundary when the ELMs are triggered [1,2,3]). Therefore, the work is based on two levels. First, the work focuses on the empirical understanding of the pedestal behavior in JET. Then, based on these results, an investigation of the pedestal transport and an extension of the PB stability analysis is done with the GENE [6] and JOREK [7] codes.

Figure 1 shows the height of the electron pedestal pressure ($p_e^{ped}$) versus $n_e^{sep}$ for a set of JET plasmas with the same engineering parameters apart from fueling rate and divertor configuration. The JET-C dataset has higher $p_e^{ped}$ than the JET-ILW dataset. However, the two datasets align very well in the $p_e^{ped}$-$n_e^{sep}$ diagram. Moreover, the JET-ILW pulses with lowest $n_e^{sep}$ reach a pedestal pressure comparable to JET-C. This suggests that the separatrix density is one of the key parameters to understand the difference between carbon and metal wall. The higher $n_e^{sep}$ in JET-ILW is likely due to the higher neutral pressure, as recently discussed for JET-ILW [8] and AUG [9], produced by the higher gas fueling and/or different recycling. In figure 1, note that the subsets with different divertor configurations show no systematic difference, strengthening the hypothesis that the neutral pressure plays the key role.

The standard PB stability analysis performed with ideal MHD can only partially explain the empirical trend. This is shown in figure 1 by the red line, which represents the pressure predictions obtained with the Europed code [10]. The increase in $n_e^{sep}$ initially leads to a sharp reduction in the predicted $p_e^{ped}$. This is due to the fact that the increasing $n_e^{sep}$ is intrinsically linked to the outward shift of the $n_e$ position ($n_e^{pos}$), shifting the $p_e$ profile and destabilizing the PB modes [3,11]. While this explains rather well the JET-C trend, the effect saturates at high $n_e^{sep}$. The prediction significantly overestimates the experimental $p_e^{ped}$ for the JET-ILW pedestal with high $n_e^{sep}$.

Therefore, the next steps are to understand the mechanisms that (1) set the pedestal gradient and (2) trigger the ELMs at high $n_e^{sep}$. First of all, we note from figure 1 and figure 2(a) that the reduction of pedestal gradient is correlated with the increase in $n_e^{sep}$ and in $n_e^{pos}$-$T_e^{pos}$. The increase in these parameters leads to the increase of $\eta_e$ (ratio between $n_e$ and $T_e$ gradient length) [3], which in turn can destabilize microinstabilities, increase turbulent transport [12, 13] and hence reduce the pressure gradient. This hypothesis is under investigation with GENE and is supported by preliminary results shown in figure 2(b), where the growth rates (mainly of ETG modes) are higher in pedestals with higher $n_e^{sep}$ and higher $n_e^{pos}$-$T_e^{pos}$ [14,15].

Then, it is necessary to understand the ELM triggering mechanisms. The discrepancy between the experimental results and the ideal MHD results is quantified with the ratio $\alpha_{crit}/\alpha_{exp}$ (where $\alpha_{crit}$ is the normalized pressure gradient predicted by ELITE and $\alpha_{exp}$ is the experimental one). Figure 3 shows that $\alpha_{crit}/\alpha_{exp}$ increases with increasing resistivity. This suggests that resistivity might have a destabilizing effect on the PB modes, as theoretically discussed in [16]. This hypothesis is currently under investigation with the non-ideal MHD non-linear code JOREK.

The picture that is emerging is the following. Due to higher gas fueling rate / different re-cycling, JET-ILW has higher neutral pressure than JET-C. This leads to higher $n_e^{sep}$ and higher $n_e^{pos}$, producing higher $\eta_e$, increasing the turbulent transport and reducing the pedestal gradient. In turn, the lower pedestal gradient leads to a lower temperature inside the separatrix, increasing the resistivity and making resistive effects on the MHD stability non-negligible.

References
[1] Beurskens M. et al., NF 54 043001 (2014)
[2] Maggi C. et al., NF 57, 116012 (2017)
[3] Frassinetti L. et al., NF 59 076038 (2019)
[4] Giroud C et al., IAEA FEC, EX/3-4 (2018)
[5] Beurskens M. et al., NF 56 056014 (2016)
[6] T.Görler et al., JCP 230, 7053-71 (2011)
[7] Huysmans G. et al. NF 47, 659 (2007)
[8] Frassinetti L. et al, to be submitted to NF
[9] Kallenbach A. et al., NME 18, 166 (2019)
[10] Saarelma et al., PPCF 60, 014042 (2018)
[11] Dunne M. et al., PPCF 59, 014017 (2017)
[12] Hatch D.R et al., NF 57, 036020 (2017)
[13] Kotschenreuther M. et al., NF 57 064001 (2017)
[14] Chapman B. et al., to be presented at the 47th EPS conference
[15] Hatch D.R et al., NF 59, 086056 (2019)
[16] Wu et al., PoP 25, 092305 (2018)

Country or International Organization Sweden Division of Fusion Plasma Physics, KTH, Stockholm SE

### Primary author

Lorenzo Frassinetti (KTH, Royal Institute of Technology)

### Co-authors

Dr Ben Chapman (CCFE) Guido Huijsmans (CEA, IRFM) Jon Hillesheim (Culham Centre for Fusion Energy) Samuli Saarelma (CCFE) Costanza Maggi (CCFE) Stanislas Pamela (CCFE - UKAEA) Anthony Field (CCFE) Alexandre Fil (CCFE-UKAEA) Colin Roach (Culham Centre for Fusion Energy) David Hatch (Institute for Fusion Studies, University of Texas at Austin) Dr Christian Perez von Thun (IPPLM)

### Presentation materials

 IAEA2020_talk_frassinetti_v7.pdf summary_slide.pdf